Taking Up Carpet

Carpet glue is an incredibly strong adhesive designed to fix rolls of carpet to concrete floors.

Taking up carpet.

Fold back about 3 ft. Remove the 3 foot wide carpet sections from the tack strips by shaking the carpet in a back and forth motion while pulling it up from the surface of the floor. Learning how to clean old hardwood floors after removing carpet is easier than most people think it simply takes a little bit more time than a traditional floor clean. If you are trying to salvage the floor underneath make sure you do not cut grooves in the floor with the knife.

Thus you shouldn t have to remove the baseboards when taking out smelly carpet. Pull up a few feet of carpet and fold it over. The carpet will be connected to the concrete surface via a series of wooden strips to which the carpet is tacked. One way to do this is to lift the carpet away from the floor as you cut.

To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. Remove this small piece of carpet and then pull up on the larger section. Start at one corner of your room and try to pull up the carpet. Keep both hands on the knife to avoid cutting a free hand.

Though incredibly effective this specialty glue is also notorious because it leaves behind sticky residue that is hard to remove with traditional removal methods. Use a utility knife with a sharp new blade to cut through the carpet backing. Roll or fold the strip secure with duct tape and remove it from the room. Use a utility knife or carpet knife to slice the carpet into manageable strips and roll the strips up as you go.

Take any doors off the hinges that swing into the room where the carpet will be removed using a screwdriver and hammer. Of carpet and cut it into easy to handle strips photo 1. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. Pull back a corner of the carpet using a pair of pliers.

Lifting up a carpet is a lot easier with the help of an assistant. If it won t come up then cut a small 6 inch by 6 inch square in the corner with your utility knife.